Drop-in Mosfet
Do you want to achieve a higher ROF and faster trigger response? Are you planning a power upgrade of your gun? In that case, you need a MOSFET.
It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. As a result, you gain a higher ROF of the gun and a faster trigger response.
|
Programmable firing modes
With this mode you can program to: semi only/binary/semi-auto/semi-burst/burst-auto
*Burst is programmable form 2 to 5 BB's
|
Active braking
Do you care about realism? Would you like to increase the life of the gearbox? Does your rifle have such high rate of fire that you are not able to make a single shot? Active brake will sort things out.
In SEMI Mode, the brake will not allow for compressing the piston after a shot. The piston will stop in front position which eliminates unnecessary stresses, increasing the service life of Gearbox and its parts. It is very important, especially with an AEG power upgrade.
After releasing the trigger, the rifle immediately stops shooting. Thus, you will gain more realism and, additionally, won’t lose your precious ammunition.
|
Precocking
Victory in the game is often a matter of fractions of seconds. Thanks to PRE-COCKING, you gain a trigger reaction similar to a real gun. It allows for initial spring compression, which speeds up the trigger response significantly.
*Please note: using PRE-COCKING increases wear and tear on the gearbox.
|
Binary trigger
Fires one shot on the trigger pull and another shot upon release.
|
Two-stage trigger
Light trigger pull results with a single shot or burst, while a deeper pull will cause a burst or fully automatic fire.
Available firemodus: semi only/binary/semi-auto/semi-burst/burst-auto.
|
Trigger sensitivity
The trigger can be set to 5 sensitivity levels, ranging from very short pull needed to fire a shot, to a very long one.
The trigger sensitivity change is possible even in the field.
|
ROF reduction
With the Rate Of Fire reduction you can reduce the rate of fire to save ammo or for more realism.
|
DSG mode
The Perun AUG mosfet can be used in combination with a Dual Sector Gear setup.
|
Diagnostic system
When there is something wrong with your gun, the diagnostic system will tell you what the problem is.
|
Battery Protection
Protects your LiPo battery against running out of juice. When low on power the mosfet will indicate this with sound signals every 30 seconds.
|
Electronic Fuse
Protects your gun and battery
|
Ultra-low resistance wiring
Muldental silicone wiring, seen as the best wiring for your airsoft replica!
|
DEANS-T Ready
The product has factory-fitted low-resistance deans-t connectors.
|
Up to Li-Po 14,8V
The Perun mosfet can be used with batteries up to and including 14.8V LI-PO.
|
Compatibility
Perun AUG Mosfet was tested with positive outcome in gearboxes of the following manufacturers: Tokyo Marui, ASG, Classic Army, Army Armament en JG
|
Nederlands
